Get started

How to use your peptide kit

Two short videos show you exactly how to reconstitute your peptides and fill your dosing pen. No experience needed, just follow along.

Watch the videos Open the dosing tool

Research use only. Not for human consumption.

The full picture

Your kit goes together in four steps

Everything you need is in the box. Two of these steps, mixing and loading, are covered in the videos below.

Reconstitute: adding bacteriostatic water to the peptide vial with a syringe

Video 1

STEP 01

Reconstitute

Draw bacteriostatic water with the syringe and add it slowly to the peptide vial. Swirl gently, never shake.

STEP 02

Draw your dose

Use the extraction syringe to measure your starting amount accurately from the reconstituted vial.

Load the pen: twisting a fresh needle head onto the aluminium peptide pen

Video 2

STEP 03

Load the pen

Transfer into the aluminium pen and twist on a fresh needle head, ready for a clean, precise dose.

Dose and store: dialling the dose on the pen, then refrigerating the kit

STEP 04

Dose & store

Dial your amount on the pen, then return the vial to the case and refrigerate at 2 to 8 °C between uses.

Watch it done

The two key steps, on video

Never done this before? These short, clear walkthroughs take you from a sealed vial to a loaded pen.

Reconstituting your peptides

How to mix bacteriostatic water into your vial, the right way.

Filling your peptide pen

Loading your reconstituted peptide into the pen, ready to dose.

Before you start

Have your kit on a clean, flat surface with good light.
Check the kit contains your peptide vial, bacteriostatic water, the pen, needle heads, an extraction syringe and the thermal case.
Wash your hands and wipe the vial tops before you begin.
Swirl gently to mix, never shake the vial.
Refrigerate at 2 to 8 °C between uses.

Once your pen is loaded

Pen & dosing toolTurn your amount into exact pen clicks, no maths. Reconstitution guideThe full written walkthrough and mixing ratios. Peptide research libraryRead the science behind each peptide in your kit.

Good to know

Common questions

Do I need any experience to use the kit?

No. The two videos on this page walk you through reconstituting your peptides and filling your pen. If anything is unclear, message us on WhatsApp and we will guide you through it.

What do I use to mix the peptides?

Bacteriostatic water, which is included in every kit. You draw it with the syringe, add it slowly to the vial and swirl gently, never shake.

How should I store the kit between uses?

Return the vial to the thermal case and refrigerate at 2 to 8 degrees Celsius between uses.

Stuck on any step?

Message us on WhatsApp and a real person will walk you through reconstitution, the pen and dosing, so nothing is guesswork.

Chat on WhatsApp